Wall faucet with knobs and spout | 340x (H) 880mm | different models

Wall faucet with knobs and spout | 340x (H) 880mm | different models

Product description:

Wall-mounted sink mixer with knobs, washer, swivel spout and bracket fixing the battery to the wall. The battery is equipped with check valves. The distance of the battery tube from the wall is 9 cm. Range of the spout from the wall 43 cm. Spacing of 150 mm connection sockets.

GASTRO BATTERY FIT BATTERY INSTALLATION INSTRUCTIONS 4

• 1. Two-handle, wall-mounted mixer.
• 2. Mounting kit for connecting the battery with the installation.
• 3. Chromed pipe with a changeover valve.
• 4. Swivel spout.
• 5. Pipe bracket with stainless steel screws and Ø 8 mm expansion bolts.
• 6. Hand shower holder.
• 7. Manual spray with lever and plastic ring for setting a continuous outflow.
• 8. Shower hose in stainless steel cover.
• 9. Chrome-plated spring of the spray hose.
• 10. Instructions.

BATTERY MOUNTING:

• 1. Connect the battery to the water supply system using the components included in the assembly set.
• 2. Insert the end of the pipe into the battery connector and connect the pipe with the battery by tightening the nut with your hand.
• 3. Put the bracket on the pipe and block it 10 cm from the hexagonal element in the upper part of the pipe.
• 4. Shorten the bracket arm to the required length, place it in the foot of the bracket and lock by screwing a screw in the side wall of the presser foot with a 2.5 mm Allen key.
• 5. Press and drill holes in the wall for Ø 8 mm expansion bolts and attach the bracket to the wall.
• 6. Disconnect the pipe from the bracket and remove the pipe from the battery.
• 7. Connect the pipe with the hose - to do this, lock the hose nut with a 24 mm flat wrench and screw in the pipe end (using a 34 mm spanner or adjustable spanner) by turning the hexagonal element in the upper direction clockwise. parts of the pipe.
• 8. Loosen the 2.5 mm Allen key screw in the plastic ring at the lower end of the spring and push the spring downwards until the ring rests against the hexagonal stop. In this position, lock the ring by screwing the locking screw slightly (not fully) with the Allen key.
• 9. Connect the whole with the battery and with the bracket previously attached to the wall.
• 10. Fix the washer holder at a distance of 10 cm below the wall bracket.
• 11. Install the spout.

INSTALLATION COMMENTS:

• 1. Tightness tests should be carried out before installing the battery.
• 2. On water supply installations supplying the battery, use filters to stop mechanical impurities.

CONSUMER REMARKS:

• 1. After using the battery, close it. Do not leave the hose and washer under pressure.
• 2. Clean chromed surfaces with soap and water. Do not use chemical cleaners